Displays
When idle, the KEGMETER automatically sequences thru several of these displays and your user messages to give you and your guests something to watch. All listed displays can be selected using the MENU switch.
TimeDate
Shows day of week, date, and time of day (12 hour AM/PM ).
Gone
Shows how much beer is gone. Selectable units include pounds (LB), %, GAL, Empty/Full bar graph, db down, l, raw counts (cy), or ounces (oz).
Remain
Shows how much beer is left, which is difference between selected keg size and amount of beer gone.
Served
Shows how much beer was most recently served.
Change
Shows how much beer has been served since last pressed the ACK button while in Change mode.
TimeToGo
Shows an estimate of how long the keg will last. Estimate is made by dividing the beer remaining by the average rate of consumption since the first serving. The most interesting thing about this display is that if it is steadily decreasing you know you will finish the keg.
E Time
Shows time elapsed since the first serving.
ECU Temp
Internal temperature of the Electronic Control Unit
Keg Temp
Temperature read by the keg temperature sensor.
Pressure
Pressure of incoming CO2 gas.
SOV1
Outlet pressure of solenoid operated valve #1. SOV 1 opens the faucet.
SOV2
Outlet pressure of solenoid operated valve #2. SOV 2 closes the faucet.
Power In
Charge power input voltage.
Battery
Battery voltage.
5v Power
Internal supply voltage monitor.
PeakRate
Peak flowrate measured during last serving.
FlowRate
Actual flowrate.
Ave.Rate
Average flowrate since first serving.
Alarm Displays
When an alarm is activated, it flashes the master caution lights, activates the alarm tone (if not muted), and flashes the applicable message below on the display:
TEST
Activated by selecting TEST on the alarm mode toggle switch.
ECU HOT
Activated if ECU internal temperature exceeds limit.
No ECU T
Activated upon loss of ECU temperature sensor readings.
FOAM
Activated when the beer flowmeter senses excessively high flowrates. This condition is almost exclusively caused by a lack of beer in the line.
BEER HOT
Activated if beer temperature gets too hot.
FREEZE
Activated if beer temperature gets below freezing.
No Keg T
Activated upon loss of beer temperature sensor readings.
PRESS HI or PRESS LO
Activated if CO2 pressure gets too high or low, respectively.
BEER LOW
Activated when you're almost out of beer.
BATTERY
Activated if the battery voltage gets low.
POWER
Activated when the power input voltage gets low.
NEW KEG
Activated after performing a keg RESET when starting a new keg.
ABORT
Activated if the faucet is manually closed during an automatic serving.
Picture | ECU details | Single-Handed | Alarm Clock | Messages | Price | Availability | Why Buy? | Kegmeter | Home
Last update 30 April 2003. Copyright© 2003 Kegmeter Electropneumatics, All rights reserved.